Image : http://www.flickr.com
A port is a very important part of your house, is used when you visit with your guests or unexpected visitors, going to pop. If you do not know of a bell, it was not simply that people are at your door. They need to hire someone to answer the bell, you can do it myself. This is one of the simplest and easiest electrical projects that you can do alone.
Installation
This is the best project "do it yourself for a beginner to startuse. The simplest form of installation of a bell, book, if not already mounted. If you do not already have a bell, you could buy a wireless doorbell.
A wireless doorbell is a radio transmitter and a receiver which means you are not using a cable to connect the two devices together.
There are many advantages of using the wireless door bells, including:
If you have hearing problems, may be subject to a use more than one recipientdifferent electrical outlets around the house. This allows you to hear the bell wherever you are at home.
These require no wiring and are powered by a small battery that lasts for a very long time.
Replacing a wired doorbell is easy compared to many other projects DIY, but are faster wireless than that! The longer you spend with the choice of the surface of the alarm system that you want to use.
Replacement of an existing doorbell
If your old bell is brokenand must be replaced then you have few options. If you do not have much time, then you can easily remove the wires and install one of the wireless models. This is very simple and straightforward.
When replacing a wired doorbell then it is not very long standing. Provided, of course, the cord is not damaged. The tools you need urgently a new bell and a screwdriver. You may also need some wire stripper.
You really need to contact the electricity, unless thethis. Although doorbells are low voltage and only 12 volts, you can do this without turning off the projector. That even the slightest indication that this is the highest tension, or are not sure, then turn off the device.
Begin removing the old bell reject, only the screws and pull out. Unplug the power cord and take the old switch.
If necessary, you should cut the umbilical cord and part of the strips of insulation over it.
Connect the cable toLock-up connection in the new doorbell button and disconnect the terminals. No matter what order they are connected, how it will deal one way or another, it's just a switch!
Connect the new switch and push the wires through the holes so that it matches the door frame. After activating the device back on it should work already. All you have to do is pass the test to see if it works.
You can also change the unit of call if you wish. You need to followprocedure similar to this, but the direction, the cables are connected can make a difference and lead to work in opposite direction.
0 comments:
Post a Comment